A wireless mobile phone battery charger is a device that charges a compatible cellphone or mobile phone placed close to it, through high frequency wireless current transfer, without any physical contact. In this post I have explained how to build a wireless cellphone battery charger circuit for facilitating a cordless cellphone charging without employing a […]
Newly Updated Circuit Projects:
How Wireless Power Transfer Works
Wireless power transfer is a process in which electrical energy is transferred from one system to another system through electromagnetic waves without using wires or any physical contact. In this post I have explained regarding how wireless power transfer works or the transfer of electricity through air without using wires. You might have already come […]
CDI Tester Circuit for Automobiles
The first design below shows a simple workbench setup for testing all types CDI circuits. It uses a capacitive discharge ignition circuit along with a CDI coil to implement the testing procedure. Audio/Video Representation The circuit does not require any separate oscillator, rather the 100Hz from the bridge rectifier itself works like a pulsed trigger […]
Rotating Beacon LED Simulator Circuit
In this post I have explained a simple LED flashing beacon circuit which exactly simulates a rotating police beacon light by generating alternating pulses of suddenly rising and fading illumination effect on the connected LED. The idea was requested by Mr. Ankit Agarwal Technical Specifications Can you advice on how to make the following circuit […]
Submersible Pump Start/Stop Circuit
In this post I have explained an automatic submersible pump start, stop circuit with dry run protection in order to implement an automatic ON/OFF switching of the motor in response to the high/low water levels of the overhead tank. Circuit Concept In one of the previous posts I have explained a similar concept which also […]
Motorcycle Regulator, Rectifier Tester Circuit
The motorcycle regulator, rectifier tester circuit presented here can be used to test a 6-wire shunt type regulator-rectifiers for a 3-phase charging system of motorcycles. These reg./rectifiers (RR-units) are usually sealed with epoxy and it is considered difficult to find out if the unit is faulty or not. Designed and Written by: Abu-Hafss As the […]