By: Girish Radhakrishnan
The heart of the mic amplifier circuit is an op-amp LM324 which is quad op-amp moulded in single IC. We are going to use one of them for our project. Readers can try different op-amp such as IC 741 etc or IC LM321.
Microphone is a device which converts sound waves into electrical signals. But the raw electrical signal from the microphone is not enough to process signals for your project.
A typical microphone used for hobby projects may give out approximately 0.02V peak to peak signal, which is insufficient to detect by an IC or microcontroller. To produce higher voltage signal, we would need an amplifier.
The major advantage of an op-amp based amplifier is that we can adjust the gain by changing the specific resistor values.
The gain of the shown amplifier is given by:
If we are connecting a headphone at the output, we need at least 2V peak to peak signal in order to hear reasonable amount of sound. So, we need to amplify the given signal by at least 100 times.
Output = 0.02V x 100 = 2V
The amount or the times by which you are going to amplify the input signal is called “gain”. Here the gain is 100. It is a dimensionless value, hence there's no unit.
It is recommended to keep R1 value constant for beginners and change R2 value for adjusting the gain.
Here we are keeping R1 value as 1K ohm and R2 as 100K ohm. Applying the gain formula we get 100 as the result.
Gain= 1+ (100K/1K) = 101 (Gain)
So if you are going to connect something more powerful such as a small speaker, we may need to increase the gain yet more.
Always remember, you cannot get something more from the nothing, therefore we need to apply sufficient voltage at the input.
If you need a peak to peak 10V, you need to apply at least 12V; otherwise clipping might occur at the output. This may not give good and clean sound output.
The proposed microphone amplifier circuit can amplify the input signal thousands of time; this doesn’t mean that you may drive a home theater speaker.
This circuit can merely output the current at mA range. If you need to drive those bulky speakers you may need current greater than 1 ampere.
The power source is differential power supply, which consists of two 9V battery coupled with capacitors for smooth and noise less power. 2.2uF capacitor is for eliminating DC voltage entering the IC.
4.7K resistor helps powering the microphone. R1 and R2 is gain adjust resistor, you may calculate your own values. 2.2uf capacitor at the output is to truncate DC components.