In this post I have explained an electronic engine speed governor or controller circuit using an RPM feedback signal loop through a hall effect sensor network. The idea was requested by Mr. Imsa Naga. Circuit Objectives and Requirements Thank you very much for your time. I believe this circuit would be suitable for a single […]
Electronic
Electronic Door for Pets Circuit – Opens when Pet Nears the Door
In this post I have explained a simple electronic door circuit for pets which can be used as an electronic dog door for allowing only your specific pet dog to use the entrance, while keeping it locked for “strangers”. The idea was requested by Mr. Dave Monette. Circuit Objectives It’s been a while since we […]
Electronic Component Buying Guide for New Hobbyists
Are you a beginner to electronics? Then here are few guidelines which might help you to buy some really useful components, so that you are always for an electronic and are never short of some crucial component.. OBJECTIVE: Not only for beginners, this will also help other hobbyists to buy some most commonly used components. […]
Mains 20 Watt Electronic Ballast Circuit
In this post I have explained a simple 20 watt fluorescent ballast circuit using a single chip FAN7711 from Fairchild semiconductor. The proposed mains 220V operated, 20 watt fluorescent ballast circuit is built around an LCC resonant tank and a half-bridge network. Implementing Zero Voltage Switching The main features and operations may be understood with […]
Electronic Scoreboard Circuit Using IC 4033 Counter
A simple multi-digit electronic score board system can be built using a basic 4033 IC counter circuit. The whole procedure is explained in the following article. So far we have learned quiet a lot about this interesting IC 4033 through the following posts that have comprehensively discussed the pinouts and cascading procedures of the chip. […]
Electronic Load Controller (ELC) Circuit
In this post I have explained a simple electronic load controller or governor circuit which automatically regulates and controls the rotational speed of a hydro-electric generator system by adding or deducting an array of dummy loads. The procedure ensures a stabilized voltage and frequency output for the user. The idea was requested by Mr. Aponso […]