This Arduino basics discusses the method of implementing a code through which the ON or OFF state of an external push-button could be read or monitored within the Arduino. Digital Read Serial Here I have explained through an example how to monitor the state of a switch by performing serial communication across your Arduino and your PC via USB. In excess to your […]
Newly Updated Circuit Projects:
Blinking an LED with Delay – Arduino Basics
Here I have explained the bare minimum code for compiling an Arduino and also the method of blinking an LED using an Arduino board. Learning the Bare Basics Here we discus and try to understand the fundamental minimum code that one would need to compile an “Arduino Sketch” which consists the setup()method and the loop()method. […]
Arduino Mains Failure Battery Backup Circuit
In this article I have explained a simple mains failure backup circuit for providing Arduino boards an uninterruptible supply during such situations. The idea was requested by Mr. Fredrik. Technical Specifications This blog gave me a lot of interesting information. Especially the power supply circuit with battery backup part. The reason for this is that […]
ATmega32, Pinouts Explained
The Atmel AVR Atmega32 is a low power CMOS based microcontroller chip manufactured on the AVR advanced RISC architecture. It is featured for carrying out technologically powerful instructions within each of its clock cycles. The chip is also equipped with the capability of achieving throughputs rated at 1MIPS per MHz enabling the system manager to enforce […]
Microcontroller Basics Explored
One thing is great about microcontroller ICs, these are available almost in all parts of the globe and electronic retailers. Introduction Fundamentally microcontroller devices are popularly used in applications involving assessments of the surrounding environment and in similar electronics. You could find these devices being used for displaying a certain parameter, in motor control applications, […]
How to Drive High Watt LEDs with Arduino
In this post I have explained the method of incorporating high watt LEDs with Arduino through external high voltage supplies. The question was put forth by Mr. Cole. The Circuit Question I stumbled upon your blog and I love it! So much great information and great ideas Right now I am trying to figure out […]