In some of my earlier articles we have seen a few simple and interesting temperature indicator circuits, in this article we will try to upgrade one of them into a sequential form.
All these circuits are useful in some or the other ways, however these are not equipped with step wise temperature level indicator arrangement and therefore tracking the varying levels of temperature cannot be identified using them.
The present design eliminates the above issue, as here the entire temperature range becomes visible through an arrangement of an LED array.
20 LED Sequential Temperature Readout
The LEDs in this circuit reads the temperature levels discretely via 20 steps of LED indications.
The proposed sequential LED temperature indicator circuit is definitely the simplest to build, since it is based on a single outstanding IC LM3914 from TEXAS INSTRUMENTS, which single handedly performs the whole action of displaying the readings in a sequential manner.
The LEDs show an incrementing temperature through a single illuminated LED at the relevant positions of the array, thus the present design shows a dot mode indication instead of a bar graph.
The dot mode arrangement specifically helps to save battery power because only one LED is involved for the required indication at any instant.The IC LM3914 is basically a millivolt measuring device which is able to convert a varying milli volt input into a corresponding LED readout at its output pin outs.
Here the input is derived from another interesting IC LM35 from TEXAS INSTRUMENTS, which is configured as an ambient temperature sensor device.
LM35 for Temperature Sensing
The IC LM35 coverts the temperature differences around it, directly into varying milli volts across its output.
For every single degree change in the temperature, the IC LM35 generates an output with a 10 mV variation.
This correspondingly varying milli volts is applied at the input of the IC LM3914, which readily accepts these variations, making them visible at the output through the connected LEDs.
Thus as the temperature around the IC LM35 increases, it generates a correspondingly increasing mV across its outputs which is in turn transformed by the IC LM3914 into an LED readout, displaying the relevant level of the sensed temperature.
The LED array should be appropriately calibrated, through some trial and error and some practical experimentation.
Questions & Answers
How are you!!! I would like to implement that circuit to the vehicle’s engine to monitor its temperature since it is manufactured, my car does not bring it, it is a 2002 Ford Ka.
I am good, thanks…Sure, you can use the above circuit for monitoring your car engine heat…let me know if you face any problems with the circuit.