In this post I have explained a simple op amp based thermocouple temperature meter circuit which can be used for measuring high temperatures in the range of 100 °C to 1000 °C, in heaters, furnaces, kilns tec. What is a Thermocouple A thermocouple is a simplest and the cheapest form of temperature sensor device, built […]
Meter
3-Digit LED Capacitance Meter Circuit
This project is yet another test equipment that can be extremely handy to any electronic hobbyist, and building this unit can be a lot of fun. A capacitance meter is a very useful test equipment as it allows the user to check a desired capacitor and confirm its relaibility. Ordinary or standard digital meters mostly […]
Transmitter Receiver Circuit for 80-meter Ham Radio
This tiny and simple transmitter, receiver set will allow you to communicate over 100 of miles across the world, by tuning to 80-meter amateur ham radio stations. What is 80-meter Band The 80-meter uses 3.5 MHz frequency band for radio communications, which gets the permissions under amateur radio use Between 3.5 to 4.0 MHz in […]
2 Meter Ham Radio Transmitter Circuit
In this post I have explained the complete building procedure of a 2-meter amateur ham radio transmitter circuit, using ordinary electronic components and ordinary test equipment. What is 2-Meter VHF Radio The 2-meter amateur radio band is a section of the VHF radio spectrum, which includes frequencies ranging from 144 MHz to 148 MHz in […]
Automobile Engine RPM Servicing Meter Circuit (Analogue Tachometer Circuits)
These useful lightweight, cheap, analogue tachometer circuits are developed for facilitating car or auto servicing mechanics for precisely adjusting a car ignition system RPM to get maximum efficiency from it. The proposed circuits are actually combined results of a tachometer and a dwell meter. Application The car RPM servicing meter circuit can be applied for […]
Simple Frequency Meter Circuits – Analogue Designs
The following simple analogue frequency meter circuits can be used for measuring frequencies which may be either sine wave or square wave. The input frequency which is to be measured must be at least 25 mV RMS, for optimal detection and measurement. The design facilitates a relatively wide range of frequency measurement, right from 10 […]