This LM317, LM338 calculator software is used as a tool to determine the value of the
voltage adjusting resistor needed to assign the output of an LM317 to an
allocated degree. Normally R1 is 220 ohms or 240 ohms, however it could very
well be a different value for instance 150 or 470 ohms. Go with a value for R2
and click the "Calculate" button. The LM317 output value is displayed in volts.
Take into account that the input voltage to the LM317 is required to be a
minimum of 1.5v higher than the output voltage. To increase current you can configure an outboard transistor across the input and output pins of the IC
Muy buena información me gustaría seguir recibiendo
Thank you!
I want to make the current limited PWM Li-Ion charger to charge 15V,/ 6800 mah Li-Ion battery.
Sorry, I do not have a PWM based charger with me at this moment.
sus terminos son exactos,es uno de mis maestros preferidos desde ahora. GRACIAS MAESTRO.
My pleasure Alfredo!
Just want you to include feedback on the arduino inverter, thank your the best.
Hi. very, very gooood page.Please write me to send you some circuits and to clear daubs. Thanks so much Joakko
Observing the above software I discovered that the parameters are related by V=(1.37XR)/r. Where V is the outputvoltage, R is R2 and r is r1.
Please try this with many values of resistors it should swing within this constant.
Swag. kindly look into my last mail on using micro-controllers to design inverter with just a single transformer.
Cheers.
OK you mean the reference voltage value is 1.37 V instead of the specified 1.25 V in the datasheet…I have not yet investigated I may do it in my free time…
Very good explained thanks