The proposed 50 watt (and higher) LED street light driver circuit uses the IC L6565 as the main control device, which is basically a current mode primary controller chip especially built for quasi-resonant ZVS fly-back converters. ZVS stands for zero voltage switching.
The chip implements the said quasi-resonant function by sensing the demagnetization of the transformer and by subsequently switching the mosfet for further actions.
A feed forward feature enables the IC to compensate for the variations of the mains voltage which in turn takes care of the converters power handling capability.
In case the connected load is lower than the specified magnitude, the device correspondingly adjusts and compensates the operating frequency without affecting the ZVS feature by much.
In addition to the above features the IC also includes a built-in current sensor, an error amplifier with accurate reference voltage and a versatile two step protection against overcurrent load conditions.
More details regarding the IC L6565 can be found in its datasheet.
The remaining configuration of the converter is standard and may be understood as follows:
The mains 120/220V AC is fed to the bridge rectifier B1 via an EMI filter L1.
The rectified voltage is filtered by C1 and applied to the primary section of the converter which comprises the IC L6565 along with the ferrite transformer primary winding and the switching mosfet.
The IC instantly triggers itself and the mosfet, implementing the featured ZVS operations and switching the mosfet at the specified compensated rate, depending upon the mains input level.
The output of the transformer responds to this and generates the required voltages across the respective winding.
The outputs are appropriately rectified and filtered by the connected fast recovery diodes and high voltage filter capacitors.
N2 can be sen specified with an output of 105V at 350mA.
Other auxiliary winding which are included produce 14V (@1amp) and 5V (@50mA) which may be used for other relevant applications such as charging a battery or illuminating a pilot lamp.
The opto IC3 is as usual included for ensuring a constant output in terms of voltage, current and for providing the relevant output information to the chip so that the necessary protective actions can be enforced by the chip during adverse situations.
The transformer winding details for the proposed 50 watt street light driver circuit is furnished in the diagram itself.
FOR THE LED CONNECTION DETAILS, PLEASE REFER TO LED Series/Parallel Connection Details for 50 Watt Street Lamp