In this article I have explained a very simple 100 watt LED bulb circuit using a few high voltage capacitors. The entire circuit could be built at a cost less than $25. I have already discussed many capacitive type of transformerless power supply circuits in this blog, however all these suffers from a couple of […]
Newly Updated Circuit Projects:
Mini Transceiver Circuit
A transceiver is a wireless communication device which has its own transmitter and receiver units built-in for communicating with another similar device at some distant location. The user on both sides with the unit has to switch from transmitter to receiver and vice versa while speaking and hearing to each others conversation respectively. Introduction In […]
Simple LED Tubelight Circuit
An LED tube-light is lighting device built using high efficiency LEDs for illuminating a premise where it is installed, through the available AC mains supply. In this post I have explained the complete construction details of a simple LED light tube light circuit using 20 mA, 5 mm high bright white LEDs. The circuit can […]
Simple LED Music Level Indicator Circuit
An LED music level indicator is a circuit that will respond to the connected music levels and illuminate a chain of LEDs sequentially in a push-pull switching manner, in accordance with the varying music intensity. Since the illumination level of the switching LED chain appear to extend forward and backward proportionately in response to the […]
Infrared (IR) LED Flood Light Circuit
An infrared flood light is a circuit that creates an illumination over a wide range of area using infrared frequency. This infrared illuminated area can be perfectly visualized through specialized infrared gasses and IR cameras, but can be totally invisible to naked eye. In this post we study a simple infra red based flood light […]
Dummy Load Circuit for Testing Power Supplies and Amplifiers
In the following post I have explained two straightforward dummy load circuits: the first one can be used for testing high current power supplies, and the second design can be used for testing large power amplifiers. Suppose you have a 10 amp power supply and you want to confirm the 10 amp output through some […]