A transceiver is a wireless communication device which has its own transmitter and receiver units built-in for communicating with another similar device at some distant location. The user on both sides with the unit has to switch from transmitter to receiver and vice versa while speaking and hearing to each others conversation respectively. Introduction In […]
Archives for 2020
Simple Frequency Meter Circuits – Analogue Designs
The following simple analogue frequency meter circuits can be used for measuring frequencies which may be either sine wave or square wave. The input frequency which is to be measured must be at least 25 mV RMS, for optimal detection and measurement. The design facilitates a relatively wide range of frequency measurement, right from 10 […]
Easy H-Bridge MOSFET Driver Module for Inverters and Motors
If you are wondering if there’s an easy way to implement an H-bridge driver circuit without using the complex bootstrapping stage, the following idea will precisely solve your query. In this article I have explained how to build an universal full-bridge or H-bridge MOSFET driver circuit, using P-channel and N-channel MOSFETs, which can be used […]
How to Make a Solar Cell from a Transistor
The majority of newbie electronic hobbyists would certainly have a couple of burned up power transistors such as 2N3055 hiding inside their junk box. Supposing we have their internal semiconductor junctions still intact, the device could be transformed into a nice little solar cell by filing or sawing off the top cap of the device, […]
How to Make Dye-Sensitized Solar Cell or Solar Cell from Fruit Tea
The innovation of dye-sensitized solar cells has expanded the device’s potential up to the point where it might completely oust costly silicon solar cells. In the following post I have explained how you can easily construct this versatile dye-sensitized solar cell using very ordinary materials. This experiment relies on the concept of utilizing the organic […]
How an Autotransformer Works – How to Make
An autotransformer is an electrical transformer which consists of only a single, continuous, non-isolated winding, with tapped terminals across various points of the winding. The winding section between the taps that correspond to the mains AC is applied with the mains AC supply, while the remaining taps are used for getting the desired output voltages, […]