This circuit is designed to sense the whistles from a pressure cooker and count the number over a digital display. The system relieves the user from the stress of constantly monitoring the cooker and from manually counting the whistles.
The idea was requested by Mr. P.K. Bajpai
In many of the Asian countries rice is the staple food and to cook rice efficiently a pressure cooker is normally employed. We all know that a pressure cooker is preferred since it is able to cook food quickly through its high steam pressure inside. This saves energy and time both for the user.
Another advantage of this special cooking vessel is the facility to adjust the cooking degree or consistency of the food ingredient through an audible alarm in the form of whistles, also created by steam pressure. The number of whistles allows the user to understand and optimize the texture and the efficiency of the food inside the cooker, and if this is not correctly estimated results in a bad quality food or sometimes even complete destruction of the food.
Electronic Counter for Counting Whistles
As per the request I have designed a simple and cheap whistle counter circuit that will relatively accurately respond to cooker whistles and trigger a digital counter for generating the data over the display.
How the Circuit Works
The original circuit of the sound sensor was actually an ordinary MIC based amplifier designed to pick all sorts of sounds, and therefore the same design did not appear desirable for this particular project, since here I needed the device to sense only the high pitched whistles and not any other form of sound disturbances.
To modify the sound sensor into a customized whistle sensor I initially thought of applying LM 567 concept so that it filtered only the specific sound frequency.
However I did not want to make the design too complex, rather wanted to keep it simple and cheap, yet reasonably accurate.
This led me to think of an alternate solution using an opamp based high pass filter, but even this could have made the design complex, therefore ultimately I ended up designing a passive high pass filter using a capacitor and the resistor network for accomplishing the purpose.
You can see this inserted in the form C2/R7. This network makes sure that the only the high pitched, high frequency noise is able to pass through T2 and reach T3 for further amplification.
Other lower frequencies will be simply cut off and not allowed to cross the C2/R7 stage.
Before drawing the schematic I confirmed the result by imitating and creating sharp verbal hissing sounds over the MIC, I was happy to see the connected LED effectively turned ON only to these noises, whereas the other normal loud sounds hardly succeeded to produce any effect. This confirmed the sound filter stage perfectly.
However the counter is not practically checked by me, but I can assure that it will work, since the design is a standard IC 4033 digital counter application design.
R1 = 5k6,
R3 = 3M3,
R4, R8 = 33K,
R5 = 330 OHMS,
R6, R2 = 2K2,
R7 = 470K,
R9 = 10K,
R10 = 1K,
R11 = 470 Ohms,
C1 = 0.1uF,
C2 = 330pF,
C3, C5 = 0.1uF ceramic
T1, T2 = BC547,
T3 = BC557,
IC1 = 4033
Mic = electret condenser MIC.
Display = 7 Segment Common Cathode Type,
Push Button = Push to ON type,
Battery = 9V PP3 with switch
The Circuit was Successfully Tested and Built by Mr. Pradeep Bajpai. The images of the built prototype can be witnessed below:
Video Clip: The working proof of the above whistle sensor can be seen in the video which was also contributed by Mr. Pradeep Bajpai.
"Howdy friend! Are you a newcomer and looking for personalized help? Please feel free to use the comment box below for posting your queries, and get guaranteed replies within an hour!"